Skip to main content
Skip table of contents

GGU-SLAB: "Automatic (FEM mesh)" menu item

After entering the mesh nodes automatic mesh generation can be carried out using this menu item (Delauney triangulation). If an FEM mesh already exists it can be either deleted or supplemented. Under certain circumstances, "air holes" (incompletely filled FEM mesh) may occur in an existing FEM mesh being supplemented if this mesh was not generated by means of Delauney triangulation. These regions will require manual post-processing or re-triangulation of the complete FEM mesh. All newly generated triangles are assigned the material number 1.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.